Content Comparison

Universal Mount for Studio Glove

Vive Tracker 3.0

StretchSense Studio Glove universal mount (available to select when ordering Studio Glove from StretchSense website). Attach Vive Tracker with 1/4” screw.

N/A

1/4” D-Ring Screw

Lenrui’s Vive Tracker 3.0 Mount for Studio Glove

VIVE Tracker 3.0

Community-made mount by Lenrui from StretchSense Discord. Not recommended for SteamVR games with high activity - use the AMVR palm straps instead.

1/4” D-Ring Screw

AMVR Palm Straps

VIVE Tracker 3.0

Attach Ultimate Tracker using included Tundra baseplate with 1/4” screw. Make Vive 3.0 Tracker align horizontally along the strap with the LED facing your thumb.

N/A

AMVR Palm Straps

Universal Mount for Studio Glove

Tundra Tracker

StretchSense Studio Glove universal mount (available to select when ordering Studio Glove from StretchSense website). Attach Tundra Tracker using included Tundra baseplate with 1/4” screw.

N/A

1/4” D-Ring Screw

Tundra Tracker

StretchSense Studio Glove universal mount (available to select when ordering Studio Glove from StretchSense website). Attach this mount to it by sliding it over the universal mount. Attach Tundra tracker by detaching the original base and screwing it to the 3D printed mount using the PH000 screws from the Tundra base.

PH000 Screwdriver

StretchSense Studio Glove Universal Mount

Lenrui’s Vertical Tundra Tracker Mount for Studio Glove

Tundra Tracker

Community-made mount by Lenrui from StretchSense Discord. Attach Tundra tracker by detaching the original base and screwing it to the 3D printed mount using the PH000 screws from the Tundra base.

Print vertically with supports to improve stability

PH000 Screwdriver

SlimeVR Tracker Baseplate

SlimeVR

Community-made mount by Snax from StretchSense Discord. Attach SlimeVR trackers by opening the original slime case and replacing the back panel with the 3D printed part.

SlimeVR Backplate for StretchSense Mounting Clip | SlimeVR_Mount_1

Official SlimeVR case

Official SlimeVR case screws

Ultimate Tracker Low-Profile Mount for Studio Glove

Ultimate Tracker

Experimental Ultimate Tracker mount by StretchSense. Print in PLA with supports vertically on diagonal angle to improve structure. Supports must be removed cleanly using cutting pliers. Attach hair ties around thumb to stabilize while attached to glove and to reduce strain on the mount and Studio Glove electronics module.

Cutting pliers

Rubber bands or hair ties

AMVR Palm Straps

Ultimate Tracker

Attach Ultimate Tracker using included Tundra baseplate with 1/4” screw. Make Ultimate Tracker align horizontally along the strap with the LED facing your chest when your arms are outstretched.

N/A

AMVR Palm Straps

Mocopi Mount

mocopi left / right trackers

Using the T6 screwdriver, unscrew the T6 screws from the left and right mocopi wrist straps to release the magnetic base of the mount. Clip the 3D printed mount in between the two sides of the magnetic base and screw the T6 screws back in. Don’t over tighten and be careful not to strip the screws.

You must wear the other trackers in the correct position and calibrate using SlimeVR server connected to the mocopi app.

You may need to file and cleanup the 3D print to get the magnetic base to fit correctly.

T5 Screwdriver